Section 10 - K-Link; Starting K-Link; Device Connection - K-Systems G210 InviCell User Manual

K-Link

Section 10 - K-Link

K-Link software can be used to communicate with a G210 over a TCP/IP network to retrieve, display
and save a log of measurements, warnings, and daily averages into a spreadsheet. K-Link can also be
configured to send email notifications when alarms are triggered.

Starting K-Link

To launch the K-Link software, double click on the K-Link icon
NOTE: In order modify settings in K-Link such as adding a new device to the Device Connection
list, or modifying email configuration settings, K-Link must be launched with elevated administrative
privileges.
To launch K-Link with elevated administrative
privileges, right-click on the K-Link icon, then click
"Run as administrator". You may be prompted
to enter alternative credentials. Consult your IT
Department for further details.
The K-Link loading screen is displayed for a few
seconds while the software loads.

Device Connection

The device connection screen displays a list of previously saved devices to load.
A new device can be added to this list by entering its IP address, then after performing a successful
connection test, pressing "Save".
10
After loading a device, and performing a successful connectivity test, indicated by status "OK",
logging can be started by pressing "Start".
32
on the desktop or in the start menu.