Installing The Monitor - Jaco ULTRALITE 500 Series Manual

Additional tips for proper computer installation:
SFF and Thin Client: insert inside the top bay so that the on/off power button is facing the side opening.
This will allow easy on/off of the unit when needed.
Laptop: Open the laptop, place inside the top bay. The work surface on the JACO 510 model Laptop Cart
has a large opening that the laptop display will fit through as you install the work surface to the Cart.
All-In-One: The unit must have a 75mm or 100mm VESA pattern on the rear surface to mount to the JACO
520 model Mobile Cart. The hardware to mount the All-In-One is provided.
It is highly recommended that you use either the Velcro wrap strap or Velcro adhesive patches included
with all Mobile Carts inside the accessories kit to hold the PC, Thin Client, or Laptop in place inside the
Mobile Cart top assembly.

Installing the Monitor:

9
To attach the LCD to the stand. A Phillips Head
screwdriver or, if added security is needed for the LCD, a
Torx Head driver is needed to attached the LCD to the
VESA Stand. Both Phillips and Torx screws are provided.
It is recommended that one person hold the LCD while a
2nd person inserts the hardware. Make sure all 4 screws
are installed and tightened properly.
With the monitor and stand installed on the Cart, the LCD
power and signal cables can be installed. Route both
cables down through the cable management area of the
stand as shown to the left. Pull the cables into the Top
Assembly and attach to the PC or laptop computer that
will be installed later.