Battery Power System Maintenance; Battery Power System Specification - Jaco ULTRALITE 500 Series Manual

Allow time to Calibrate
5.
below, needs to learn or calibrate as the power system charges from fully drained to fully charged.
Leave the Mobile Cart plugged into the wall outlet until all 5 status LEDs are showing green indicating
that the batteries are fully charged. This step could take up to 4 hours but it is best to allow the charge
to continue over night when possible.

Battery Power System Maintenance:

There are NO serviceable parts within the JACO Power System. Should the Power System fail, review the
Troubleshooting section of this User Guide and if applicable, follow the steps provided. Please contact JACO
Customer Support as needed to resolve the issue.

Battery Power System Specification:

Model: JPS250 or JPS500
Battery: Lithium Iron Phosphate also known as LiFePO4 and LFP
AC Input: 100vac to 240vac
Input Current: 3.5 amps
Frequency: 47 to 63 Hz
Output Voltage: 120VAC /60Hz standard
Output Current: 1.5A @ 120VAC continuous
Output Power: 180 watts continuous
Operating Temperature: 32 to +95 Degrees Fahrenheit
Non-Operating Temperature: 0 to 120 Degrees Fahrenheit
Electronics Box (Inverter/Charger Unit) Dimensions: 10.6"(L) x 9.65" (W) x 2.2" (H)
Agency Certification: The JACO Battery Power System, Inverter/Charger Assembly has been tested and approved
to the following agency certifications - IEC 60601-1/A2: 1995 & IEC60950-1:2005
15
– The status gauge readout at the front top of the Mobile Cart, as shown