Power System Troubleshooting; No Power Condition - Jaco ULTRALITE 500 Series Manual

Power System Troubleshooting:

No Power Condition

1 - Check to make sure that the PC and LCD are plugged into the AC power outlet on the JACO
Power Inverter. You may be using a short tri-plug cable that is provided. Also make sure that
the Outlet Power Switch is in the ON position as shown below.
2 – If you still do not have power to your PC and LCD, disconnect the PC from the JACO Power
Inverter and plug directly into a known good AC wall outlet. This will help determine if the
issue is with the JACO Power Inverter or the PC power adaptor itself.
3 – If the PC powers up normally when plugged into a wall outlet, disconnect and plug back
into the JACO Power Inverter. If not, you may have an issue with the PC power adaptor.
Contact the PC manufacturer for a replacement.
4 – Plug the JACO Mobile Cart power cord into a known good AC wall outlet.
 Does the front status LEDs panel turn on?
 Does the JACO Power Inverter fan turn on?
 Does the PC and LCD power on?
If yes to all above, no need to continue. If the issue is not resolved, go to next step to reset
the JACO Power Inverter.
17
– "My power system is not providing power to the LCD and PC".