Bahco DTC Series Original Instructions Manual page 4

MAIN MENU
Main menu displays DTC operational information.
1. From torque measurement screen, press and hold ENTER
2. Use UP /DOWN buttons to highlight menu selection then press ENTER
Menu Selections:
EXIT - Exits main menu and returns to torque screen.
CYCLE COUNT - Displays torque cycle count screen.
SETTINGS - Displays DTC settings menu.
CALIBRATION – Displays password screen (see Calibration manual).
3. To exit main menu and return to torque measurement screen, press ENTER
menu selection is highlighted.
EXIT
ENTER
button
0 .0 0
CYCLE COUNT
held
SETTINGS
1.PEAK FT‐LBS CALIBRATION
Measurement Screen
EXIT COUNT: 12
Press
CYCLE COUNT
ENTER
button
SETTINGS
CALIBRATION
Main Menu Cycle Count Screen
EXIT EXIT
Press
CYCLE COUNT SHOW INFO
ENTER
button
SETTINGS SLEEP TIME
CALIBRATION LCD CONTRAST
Settings Menu Selection Show Info Selection
EXIT SLEEP TIME
Press
SHOW INFO
ENTER
button
SLEEP TIME
LCD CONTRAST
Sleep Time selection Sleep Time Screen
Note: Sleep mode turns off the DTC to conserve battery power. Do not apply torque while in sleep mode.
6
DTC12340
button for 3 seconds.
button.
button while EXIT
Main Menu
COUNT: 0
UP/DOWN ENTER
CLEAR CLEAR
buttons
EXIT EXIT
Cycle Count Screen
CAL: 2014/01/01
Press ENTER
CWOI: 0.00
ENTER
CWOR: 35
button
CW1I: 250.10
CW1R: 15931
CCWOI: 0.00
CCWOR: 10
CCW1I: 250.10
CCW1R: - 15870
TQZ: 18
OVR CNT: 0
VER: 1.0.0
Show Info Screen
UP/DOWN
buttons to SLEEP TIME
select from ENTER
2 min.
5 MIN 8 HR
to 8
EXIT EXIT
Sleep Time Screen
DTC12340
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
LCD Contrast Selection
Note: Calibration menu is password protected. Contact the BAHCO / SNA Europe After Sales
regarding Calibration.
EXIT
CYCLE COUNT
SETTINGS
CALIBRATION
Calibration Menu Selection
BATTERY REPLACEMENT
Replace with three "AA" cells only.
Do not attempt to recharge alkaline cells.
Do not mix different battery types.
Replace all batteries at same time.
Store DTC in dry place.
Remove batteries when storing DTC unused longer than 3 months.
Press
button
Press
button
to Exit
BATTERY
COMPARTMENT
Press
button
to Exit
Note: When Replace Battery screen is displayed DTC will no longer operate until batteries are replaced.
Only POWER
UP/DOWN
CONTRAST: 40
Buttons
to select
Press
ENTER from
button 20 to 80
LCD Contrast Screen
Press
Press ENTER
ENTER PASSWD
ENTER button
5x
button
0 0 0 0 0
Enter Password Screen
BATTERY
SLIDE- O UT
COMPARTMENT
button functions which immediately turns off DTC.
CONTRAST: 80
Press
ENTER
button
to Exit
LCD Contrast Screen
Press
ENTER
INVALID ID PASSWD
button
to Exit
PRESS TO EXIT
Invalid Password Screen
7