Cleaning Program; Vacation Program - emmeti IM-U9132045 Manual

3. Press button '
' to activate (On) or '
function; every change will be automatically memorized.
4. To exit press the ' OK ' button or else wait 10 seconds without
pressing any button.
'OFS' OFFSET SETTING
With the Offset function it is possible to correct the temperature
reading of the device by ±5°C in order to correct any systematic
reading errors due to a positioning of the chronostat in areas
unsuitable for measuring the room temperature. The device leaves
the factory with the Offset set at 0.0°C.
To adjust the Offset temperature, carry out the following steps:
1. Select the ' OFS ' parameter and press the ' OK ' button.
2. The display will show the previously set Offset temperature.
3. Press buttons ' ' and '
-5.0°C .. +5.0°C); every change will be automatically memorized.
4. To exit press ' OK ' button or else wait 10 seconds without
pressing any button.

CLEANING PROGRAM

This program is particularly useful during cleaning when windows are
open and it is pointless either to heat or air condition rooms. In such
cases the relay will remain Off for a maximum period of two hours.
To activate the program press the ' ' button: on the display the ' '
icon will light up and in place of the clock, the time remaining until the
resumption of normal operation will be displayed.
The device will go back to the previous operating mode after two
hours or if you press the ' ' button again.
' to deactivate (Off) the
' to modify the setting (range:

VACATION PROGRAM

If you intend to be away for a relatively long period it is advisable
to activate the Vacation Program, which will suspend the active
operating mode for the desired number of hours (from 1 to 95) or
days (from 1 to 99).
At the end of the set number of hours or days, the chronostat will
go back into the operating mode it was in prior to activation of the
Vacation Program. While it is off, the Antifreeze function will still be
active and the ' ' symbol will be shown on the display, along with
the countdown of the time remaining until the end of the program.
Note: Access to the vacation program will NOT be enabled while the
' cleaning program ' is on.
To activate the vacation program proceed as follows:
1. Press the '
' button: the display will show the '
the time ' h 00 '.
2. Press buttons ' ' and '
change will be automatically memorized.
Up to 95 hours, the programming is indicated in hours and the
display will show ' h XX '.
Once that value is exceeded, the device will automatically switch
to the mode for programming the vacation time in days and display
will show ' d XX '. It will be possible to increase or decrease the
hour or day by one unit at a time, with values ranging from 0 .. 95
hours and 4 .. 99 days.
3. To activate the vacation program for the set time, press the ' OK '
button again or else wait 10 seconds without pressing any button;
The display will show the flashing '
24
' symbol and
' to set the vacation time; every
' icon and the time remaining