emmeti IM-U9132045 Manual page 3

WARNING
- To adjust properly room temperature, install the thermostat far from heat sources, airstreams or particularly cold walls (thermal
bridges).
- In order to grant the electrical safety, it is mandatory to screw the chronostat body to the wall mount plate through the two
screws supplied which must be mounted in the battery holder.
- If the load controlled by the relay of the chronostat operates with mains voltage, the connection must be made via an omnipolar
switch complying with current standards and with a contact opening of at least 3 mm in each pole.
- Installation and electrical wirings of this appliance must be made by qualified technicians and in compliance with the current
standards.
- Before wiring the appliance be sure to turn the mains power off.
The device is designed to be installed in a standard recess (or wall) mounted junction box with
two or three modules or else directly on the wall using the screw anchors provided.
To install the device carry out the following steps:
1. Release the wall mount plate fitted under the base of the chronostat as shown in Fig. 1.
2. Fix the plate directly on the wall or onto 2 or 3 module junction boxes by means of the two
holes for screws (distance between centres: 60 mm or 85mm), taking care to pass the wires
through the opening as shown in Fig. 2.
3. Make the electrical connections following the connection diagram in Fig. 3.
4. Fit the chronostat onto the wall mount plate, first matching up the teeth on the base with the
holes provided on the plate and then pressing downward on the device until the plastic teeth
of the plate click into place; then fix the chronostat body to the wall mount plate through the
two screws supplied which must be mounted in the battery holder (Fig. 2).
5. Insert the batteries in the battery compartment (O in Fig. 4); see paragraph ' HOW TO
INSERT/REPLACE THE BATTERIES '.
LOAD
Fig. 3
16
TELEPHONE
INTERFACE