External Cleaning; Oven Door - LG LF761S Owner's Manual

CAUTION
• DO NOT USE ABRASIVE
CLEANSERS, STRONG
LIQUID CLEANERS, PLASTIC
SCOURING PADS, OR OVEN
CLEANERS ON THE FRONT
PANEL. THIS WILL DAMAGE
THE FINISH.
• DO NOT TRY TO BEND kNOBS
MOVING THEM UP AND
DOWN, AND DO NOT HANG
TOWELS OR OTHER SUCH
LOADS FROM THEM. THIS
MAY DAMAGE THE GAS VALVE
SHAFT.
• CONTROL kNOBS CAN
BE REMOVED FOR EASY
CLEANING.
• TO CLEAN THE kNOBS, MAkE
SURE THEY ARE IN THE OFF
POSITION AND PULL THEM
STRAIGHT OFF THE STEMS.
• TO REPLACE THE kNOBS,
MAkE SURE THE kNOB
HAS THE OFF POSITION
CENTERED AT THE TOP AND
SLIDE THE kNOB DIRECTLY
ONTO THE STEM.
NOTE
To avoid scratches, do not use abrasive cleansers
on any of these materials

External cleaning

Decorative and painted flange
For general cleaning use a cloth and hot soapy water.
For heavier soil and build-up grease, apply liquid
detergent directly over the dirty surface. Let it rest for
30 to 60 minutes. Rinse with a damp cloth and dry it.
Do not use abrasive cleansers.
Stainless steel surfaces
To avoid scratches, do not use a steel wool pad.
1
Put a small amount of cleaner or stainless steel
appliance polish in a damp cloth or paper towel.
2
Clean a small area and scrub.
3
Dry and polish with a dry and clean soft cloth or
paper towel.
4
Repeat if necessary.
NOTE
• Do not use a steel wool pad, this will scratch
the surface.
• To clean stainless steel surfaces use warm
soapy water or a stainless steel cleaner or
polish.
• Always wipe the surface in the direction of the
grain.
• Never use bleaches to clean the Stainless steel
parts.

Oven door

• Use soapy water to clean the oven door thoroughly.
Rinse well. Do not submerge door in water.
• You may use a window cleaner on the outside
of the oven door. Do not spray water or window
cleaner in the door vents.
• Do not use oven cleaners, cleanser powders or
abrasive cleansing materials on the outside of the
oven door.
• Do not clean the oven door gasket. The gasket
is made out of a threaded material fundamental
to achieve proper sealing. Be careful not to rub,
damage or remove this gasket.
MAINTENANCE 35