Changing The Settings In Each Menu Position; Changing The Settings Using The Receiver; Tro U B L E S H O O T I N G - Leica LMR 360R Operating Manual

LMR360RLeica.qxp 25/05/09
After you have made the change, after 5 seconds, you will automati-
c a l l y exit menu mode, which saves your setting. Re-enter menu mode
to change other settings.
The new settings stay in memory when the receiver and display are turn e d
off – except for the 3rd menu item (turning the receiver LEDs on or off).
7.2 Changing the settings in each
menu position
1) 1st LED indicates "accuracy menu position"
Coarse mode: Top and bottom LEDs blink
Narrow mode: 2nd and 4th LEDs blink
Use the On/Off key to change modes.
2) 2nd LED indicates "communication channel position"
The communication channels between the receiver and the remote
display may be changed – if there are two receivers on the job site,
use Channel 1 for one system and Channel 2 for the second system.
You must change the channel on BOTH the remote display and the
receiver – change the channel on the remote BEFORE changing the
channel on the receiver (see section below).
Channel 1: Top LED is lit
Channel 2: 2nd LED is lit
3) 3rd LED indicates receiver LEDs menu position
If you are working with the display only, you can turn off the
receiver LED to save battery.
If the 3rd LED is lit solid, the receiver LEDs are on.
If the 3rd LED is blinking, the LEDs are off.
4) 4th LED indicates plumb indicator menu position
The plumb indicator is useful for excavators and similar applicaitons;
when using the system on dozers, you can turn off the indicator.
If the 4th LED is lit solid, the plumb indicator function is on.
If the 4th LED is blinking, the plumb function is off.
8
16:56 Page 8

7.3 Changing the settings using the receiver

Before you are able to enter the menu mode on the receiver, it must
be turned off.
With the receiver off, press On/Off on the receiver for at least 3
seconds. Press and hold until the top LED is lit solidly, indicating
you're in the 1st position of the menu mode. Continue pressing
On/Off to scroll to the 2nd menu position.
There are two menu positions on the receiver
1) Top LED indicates "accuracy menu position"
Coarse mode: Top and bottom LEDs blink
Narrow mode: 2nd and 4th LEDs blink
Press On/Off to change modes.
2) 2nd LED indicates "communication channel position"
The communication channels between the receiver and the remote
display may be changed – if there are two receivers on the job site,
use Channel 1 for one system and Channel 2 for the second system.
You must change the channel on BOTH – change the channel on the
remote (see previous instructions) BEFORE changing the channel on
the receiver.

8. Tro u b l e s h o o t i n g

If the remote display has no signal from the receiver, check if the
receiver is:
• Out of range
• Turned off
• On a different communication channel than the remote
If there is no communication between the two units, you cannot enter
menu mode on the remote. Check the items above to establish
c o m m u n i c a t i o n .
9