Led Indicators; Software Update - Silvercrest SMRA 5.0 A1 Operating Instructions And Safety Instructions

LED indicators

orange LED on
green LED on and blue LED on
blue LED flashes slowly
blue LED flashes 3 times fast, followed by a short
pause
blue LED on
green and blue LEDs flashing fast
green and blue LEDs flashing slowly two times

Software update

As the product is constantly being developed, it can sometimes become necessary to update the software on your
device. This will be notified with a corresponding notice in the app.
Please perform the software update according to the app instructions.
Please note that the update may take up to 15 minutes, depending
on the Internet connection and the number of devices to be updated.
The update process:

The update starts loading. The blue and green LEDs light up for approx. 15 seconds, then the blue LED goes
out for a second and then the blue and green LEDs flash during the download (approx. 10-30 seconds).

Then the blue LED comes on for approx. 10 to 15 seconds.

Next, the device restarts and the update is installed. This is indicated by the blue and green LEDs flashing
(approx. 1-2 minutes).

After the update is finished, the device restarts. After the reboot, it is available in the SilverCrest Smart-Audio
App again, the blue LED is now lit constantly.
Standby mode (network connection active)
Adapter is initialising
AP mode, waiting for network connection
WPS mode, waiting for WPS signal from router
Adapter on, Wi-Fi connection OK
Wi-Fi connection fault
Maximum volume has been reached
SilverCrest SMRA 5.0 A1
English - 13