Replace The Power Cord; Remove The Rear Panel - Hypertherm Powermax30 Field Service Bulletin

Power Cord Replacement
Kit 228210 contents (CSA)
Part number
229135

The 120 V/15 A CSA plug adapter (229132) and the 240 V/20 A CSA plug adapter
(229133) must be ordered separately from the power cord kit.
Kit 228140 contents (CE)
Part number
229120
Kit 228143 contents
Part number
008389

Replace the power cord

Remove the rear panel

1. Set the power switch to OFF (O), disconnect the power cord from the power source, and disconnect the gas supply.
2. Remove the 2 screws from the handle on the top of the power supply.
3. Slightly tip the front and rear panels away from the power supply so that you can get the edges of the handle out from
underneath them. Remove the handle, and set it and the 2 screws aside.
4
Description
Power cord assembly: Powermax30, Powermax30 XP, and
Powermax30 Air L6-20P
Description
Power cord assembly: Powermax30 and Powermax30 XP CE
Description
Strain relief: 0.428 – 0.546 black vinyl
Figure 1
Powermax30/30 XP/30 AIR Field Service Bulletin 805430
Quantity
1
Quantity
1
Quantity
1