Table of Contents
Advertisement
IPC6131-WD-A&6123-WDL-A&6232-IR&6212-
IR&6231-WD-VRZ&6332-MIR&6311-IR&6331-IR
User Guide
3.1 Before You Start
l
l
l
l
l
l
NOTE
3.2 Installation of IPC6231-WD-VRZ Bullet Camera
3.2.1 Overview
The overview of IPC6231-WD-VRZ network bullet camera is shown below.
Issue 02 (2014-12-25)
Make sure the device in the package is in good condition and all the assembly parts are
included.
Make sure all the related equipment is power-off during the installation.
Check the specification of the products for the installation environment.
Make sure the power supply is matched with your required voltage to avoid damage.
If the product does not function properly, please contact your dealer or the nearest service
center. Do not disassemble the camera for repair or maintenance by yourself.
Make sure that the wall is strong enough to withstand three times the weight of the camera.
For the camera that supports IR, you are required to pay attention to the following precautions to prevent
IR reflection:
l Dust or grease on the dome cover will cause IR reflection. Please do not remove the dome cover film
until the installation is finished. If there is dust or grease on the dome cover, clean the dome cover with
clean soft cloth and isopropyl alcohol.
l Make sure that there is no reflective surface too close to the camera lens. The IR light from the camera
may reflect back into the lens causing reflection.
l The foam ring around the lens must be seated flush against the inner surface of the bubble to isolate
the lens from the IR LEDS. Fasten the dome cover to camera body so that the foam ring and the dome
cover are attached seamlessly.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3
Camera Installation
3 Camera Installation
5
Hide quick links:
Advertisement
Table of Contents
