Table of Contents
Advertisement
3.Place the charger onto the mounting bracket and fix it with the 2 screws at the
bottom of the charger. Then installation is done.
4.After the installation is done, then you can do the wiring work. Open the front lid
and the side window. Connect the AC input cables to the cable terminals through the
AC input waterproof cable gland. The size requirement of the AC input cables is:
4-6mm² for 22kW charger and 10-12mm2 for 44kW charger (Use insulated crimp
wire ferrules). The PE for 22kW and 44kW charger should be at least 4mm² and
10mm2 respectively (Use insulated crimp ring terminal).
Connect the other wires(e.g. CT wires, meter wires or LAN cable) to the
corresponding terminals through the communication waterproof cable gland. Fasten
the cable glands and turn on the RCBO inside the side window. Fix the front lid back
on the charger, then the wiring is done. Turn on the upstream breaker, and connect
the charger to computer for parameter setting. The charger will be ready for use
after the parameter setting.
If the charger is supplied by a PME system, a specific earthing rod might be
needed for the installation to comply with BS7671 regulation.
Notice
1.Only professional person can do the installation and wiring. L1, L2, L3 and N of the
AC input must not be connected incorrectly!
2.The Charger must be connected to the earth securely and reliably.
3.No live work! Please turn off the RCBO and the upstream breaker before any
maintenance work.
4.Do not disassemble the Charger except for professional persons.
After the installation and wiring is done, connect the Charger to a computer and
configure parameters via the web browser of the computer, then the Charger can be
ready for use.
4.1 Set computer's IP
The Charger's default IP address is 192.168.1.5. To access the parameter setting
interface, you'll need to first set the computer's IP to 192.168.1.x(x can be any value
between 1 and 255 except for 5, e.g. 192.168.1.10).
To set a static IP on your Windows computer:
1.Click Start Menu > Control Panel > Network and Sharing Center. (For Windows
8 and higher, search for and open Control Panel and select Network and Internet).
2.Click Change adapter settings.
IV.Parameter setting
Hide quick links:
Advertisement
Table of Contents
