Led Unit Mounting; Base Stand; Led Units - Mitsubishi Electric NP180 Series Setup Manual

Narrow pixel pitch direct view led
Table of Contents

Advertisement

3. LED unit mounting

Base stand

1.
Prepare a suitable base stand that fit into the
installation site.
2.
By means of a level, adjust the surface on the
base stand to be flat, which supports the LED
units.

LED units

Mounting
 During the work, be careful not to make an
impact or apply pressure on the LED surface and
the edges.
 It is recommended to properly put spacers (p.6)
on the LED edges for protection when mounting
the LED units.
 Due to the center of gravity, the upper part of the
LED units tends to lean to front. Hold the upper
handle as well as the lower dent to support.
14
NP180/160 Series Setup Manual
Base stand
Handle
Dent
3.
Insert adjustment screws on the base stand.
The screws are supplied with the LED units.
 The screw head is decentered. Align the longer
direction of the heads with the horizontal
direction of the base stand.
Longer direction
1.
Prior to the mounting, connect the necessary
cables to the LED units that will be located in
the bottom row.
 With the rear maintenance models, the
connection can be done after the LED unit
mounting.
12NP180
Even column
Control unit
15NP180
Even column
Control unit
Adjustment screw
Odd column
Control unit
Adapter
Odd column
Control unit
Adapter

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents