Mitsubishi Electric NP180 Series Setup Manual page 27

Narrow pixel pitch direct view led
Table of Contents

Advertisement

4.
Click the border to compensate.
5.
Change
the
brightness
"Coefficient" menu.
 The brightness of two units on the border moves
in the same time.
 The adjustment range is 80 % to 120 %.
 The scroll wheel on a mouse changes the values
by 1.5 %.
 The "Test pattern" menu located on the lower
right side the "Coefficient" menu can show
internal test patterns. The "Test patterns" menu
in the menu bar (p. 38) also shows them.
 If a border has different gaps on its both ends,
you can set different brightness level on each
end.
Select "Horizontal" or "Vertical" in the
"Gradient mode" and set different values in
value 1 and 2 columns. The values correspond
to upper/lower or left/right.
level
with
the
 You also can adjust one side of the border.
Click either side of the border to adjust after
selecting the border.
 To adjust the edge brightness on multiple
control units, adjust each side separately.
 Double-clicking an LED module / LED unit on
Wallaby shows a crosshatched pattern on the
actual display briefly so that you can check the
location where you're adjusting.
6.
Click the "Send" button on the bottom of the
window to reflect the result on the LEDs.
27
Electrical adjustment

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents