Mitsubishi Electric NP180 Series Setup Manual page 24

Narrow pixel pitch direct view led
Table of Contents

Advertisement

Follow the procedure below if you change such
starting values of the sequential IP addresses.
1.
Select the upper left panel on the panel area
or control unit select area. This panel will be
the starting point to allocate the numbers.
2.
Enter an IP address as the starting value and
set it with the "Enter" key.
3.
Click "Sequential Numbering" button and
the
sequential
automatically allocated from the upper left
panel in a horizontal direction.
10.10.10.101
ID 6
10.10.10.103
ID 8
Communication
1.
Make sure that the main power switches on the
control units have been turned on.
2.
Check the "Connect" box to connect with.
When the connection is establishment, the
connected panels will be in blue. Otherwise, the
panels will be in gray.
Power
"On" button starts supplying the power to the
connected LED units (p. 21).
LED unit location
This function sets the location of the LED units and
their ID numbers in each control unit.
1.
Click the "Location and ID settings" button. The
following window appears.
24
NP180/160 Series Setup Manual
IP
addresses
will
be
10.10.10.102
ID 7
10.10.10.104
ID 9
2.
Select the LED units to use and check the
"Enable" box.
3.
Enabled LED units show "99". Allocate
sequential numbers with the "Sequential
numbering" button.
4.
Sequential ID numbers are automatically
assigned from bottom left by output channel in
the image signal connecting order. The
channel 1 starts from 10 and the channel 2 from
20.
12NP
12
22
32
42
11
21
31
41
10
40
20
30
15NP
 When you don't use all LED units in a control
unit area, the numbering may not be
sequential. Assign new sequential numbers
with the "Sequential Numbering" button.
52
51
50

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents