Color Adjustment - Mitsubishi Electric NP180 Series Setup Manual

Narrow pixel pitch direct view led
Table of Contents

Advertisement

3. Color adjustment

After the LED module replacement (p.39) or when
fine tuning is needed after the color calibration at
the initial setup (p. 26), you can adjust the color on
an LED unit manually.
1.
Set the sensor function (p. 28) OFF or STOP if it
has been set.
2.
Move forward to the step 5 at the initial setup
that
doesn't
replacement.
3.
When replaced an LED module, click the "LED
Module Change Detection" button in the
"Color Calibration Data Acquisition" in the
"Maintenance" tab. The confirmation window
appears. Click "OK" to start searching a new
LED module. If it finds out, it automatically
reads out the color data from it to the control
unit.
4.
Next, you need to transfer the collected color
data from the control unit to Wallaby.
Click the "Read from Control Unit" button. The
following window appears. Select "Yes" to start
transferring the color data.
44
NP180/160 Series Setup Manual
require
the
LED
module
5.
In the panel area, select the control unit that
includes the LED module / LED unit to be
adjusted.
6.
Click the "Edit Calibrated Data" button. The
following window appears.
7.
In the "adjustment mode" column, select "LED
module" or "LED unit" accordingly
"LED module"
"LED unit"
8.
Click the LED module / LED unit to be adjusted.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents