Healthstream HS12.6BK User Manual page 7

F
D2
D4
K6
K3
K8
K5
K1
K8
K7
K4
K3
K2
D3
H4
D
L6
FIGURE_4 ASSEMBLY THE HANDLE BAR & BOTTLE HOLDER
Step 1.
Insert the handle bar(F) into the handle bar holder on the central tube(D).
Step 2.
Equip the handle bar(F) by the screw(K5),spring washer(K3),washer(K6),and bracket(K7)
to the up side nut.
Step 3.
Remove the preinstalled screw(D2) from the central support tube(D).Put the front console
housing(D4) into the central support tube(D) and secure it by the screw(D2).
Step 4.
Slide the sensor wires(D1&F1&F2) through the rear console housing(D3).Then equip by
knob(K1),bush(K2),spring washer(K3),and washer(K4) to the down side nut.
Please position all sensor wires(D1&F1&F2) outside of the console housing.
Step 5.
Equip the front console housing(D4) with the rear console housing(D3) by screws(K8*3pcs).
Step 6.
Remove the two preinstalled screws(L6).
Step 7.
Assemble the bottle holder(H4) with the main frame(A) by screws(L6).
Attention:
Please make sure the knob (K1) and the screw(K5) are turning tightly to avoid user falling down.
6
If you have any questions , please contact The Fitness Generation, +61 (03) 9765 9999.
Free call number 1300 796 636
www. healthstreamfitness.com.au