Safety Instructions - Gogen MAXIRADIOG Instruction Manual

SAFETY INSTRUCTIONS

1. READ INSTRUCTIONS – All the safety and operating instructions should be read before the
appliance is operated.
2. RETAIN INSTRUCTIONS – The safety and operating instruction should be retained for future
reference.
3. HEED WARNINGS – All warnings on the appliance and in the operating instructions should
be adhered to.
4. FOLLOW INSTRUCTIONS – All operating instructions should be followed.
5. WATER AND MOISTURE – The appliance should not be used near water, for example, near
a bathtub, washbowl, kitchen sink, laundrytub, swimming pool or in a wet basement.
6. VENTILATION – The appliance should be situated so that its location or position does not
interfere with its proper ventilation. Do not place on bed, sofa, rug or similar surface that may
block the ventilation openings, in a built-in installation, such as a bookcase or cabinet that
may impede the flow of air through the ventilation openings.
7. HEAT – The appliance should be situated away from heat sources such as radiators, stoves,
or other appliances (including amplifiers) that produce heat.
8. POWER SOURCE – The appliance should be connected to power supply only of the type
described in the operating instructions or as marked on the appliance.
9. POWER CORD PROTECTION – Power supply cords should be routed so that they are not
likely to be walked on or pinched by items placed upon or against them.
10. POWER LINES – An outdoor antenna should be located away from power lines.
11. OBJECT and LIQUID ENTRY – Care should be taken so that objects do not fall and liquids
are not spilled into the enclosure through openings.
12. ESD WARNING – The display does not function properly or no reaction to operation of any
the control may due to the electrostatic discharge. Switch off and unplug the set. Reconnect
after a few seconds.
13. DAMAGE REQUIRING SERVICE – The appliance should be serviced by qualified service
personnel when:
A. The power-supply cord or plug has been damaged.
B. Objects have fallen into, or liquid has been spilled into the appliance enclosure.
C. The appliance has been exposed to rain.
D. The appliance has been dropped, or the enclosure damaged.
E. The appliance does not appear to operate normally.
14. SERVICING – The user should not attempt to service the appliance beyond that described
in the user operating instructions. All other servicing should be referred to qualified service
personnel.
Notes:
A. Dirty or scratched CD may cause a skipping problem. Clean or replace the CD.
B. If an error display or malfunction occurs, disconncet the AC cord and remove all the
batteries. Then turn the power back on.
EN - 27
EN