Advertisement
Use each adaptor depending on probe type and the backwater system (see 1-3)
General: The adaptors are used to fasten the new
Probes without mounting brackets.
①
②
Installation note adaptor:
• The raised edge on the adaptors are to assure the adaptor
ist installed properly and should always be pointing up.
010-880 page 3
③
For models January 2011 and newer
①
Adaptor for all pump optical sensors
For models up to December 2010
Adaptor for all Staufix FKA and Pumpfix F
optical sensors for DN 100 (OD 110 mm) models
For models January 2011and newer
②
Adaptor for all motor optical sensors
For models up to December 2010
③
Adaptor for all Staufix FKA and Pumpfix F optical sensors for DN 125
(OD 125 mm) and DN 150 (OD 160 mm) models.
Must be used in combination with the red adaptor (adaptor
inserted into the top of adaptor
).
③
08/2011
is
①
Advertisement
