Emerson Rosemount CCO 5500 Reference Manual page 30

Install
Figure 2-9:
A.
B.
C.
D.
Procedure
1.
2.
22
Wiring Connector Locations (Control Board)
Plant status in
Analog out
Receiver cable in
Serial data input
Install the receiver cable in the center rear cable port of the control unit enclosure.
Provide adequate free wire length for making connections to the control board
terminals 16 through 22. Tighten the cable gland nut.
Connect the receiver cable wires to the control board terminals 16 through 22
according to the wiring diagram,
Do not connect the receiver cable shield wire at the control unit.
Figure 2-7.
Rosemount CCO 5500