Magnetic Switch; Contact Mat; External Microphone - Bellman & Symfon Visit Installer's Manual

VISIT ACCESSORIES
Visit accessories

Magnetic switch

Monitors the door and window
Mount the magnetic switch on the door or window frame
and connect it to the telephone transmitter. When the
magnets are separated, the transmitter signals the Visit
receiver.
Technical specifications
Dimensions 25 x 62 x 13 mm, 1" x 2.5" x 0.5"

Weight 25 g, 0.9 oz.

Connector 3.5 mm mono jack plug

Cable length 0.5 m, 1.6'

Contact breaker

Open > 1 cm, 0.4" from the magnet
Closed < 2 cm, 0.8" from the magnet
Colour White

 Environment For indoor use only

Contact mat

Signals when someone steps on it
Place the contact mat by the front door or by the bed and
connect it to the telephone transmitter or baby monitor to
be alerted when someone enters a room or leaves the bed.
Technical specifications
Dimensions 720 x 390 x 3 mm, 28" x 15" x 0.1"

Weight 290 g, 10 oz.

 Connector 3.5 mm mono jack plug
Cable length 200 cm, 6.6'

Dust proof and sealed to IP64 (not waterproof )

Operation
Contact N/O normally open

Contact resistance 1 Ω (depending on pressure)

Operating pressure Nominal 25 kg over 50 mm disc.

Temperature range -10 to 70 °C, 14 to 158 °F

53
BE9023
BE9024
Maximum ratings
Contact rating 10 VA

Switching voltage 25 VDC

 Switching current 0.25 Amps DC resistive
Carry current 0.25 Amps DC resistive


External microphone

Extends the door transmitter reach
The external microphone can be used with the door
transmitter when the sound source is located too far
away from the internal microphone or when you need
individual notifications from for example the doorbell and
intercom.
Technical specifications
Dimensions 33 x 36 x 4 mm, 1.3" x 1.4" x 0.2"

Weight 15 g, 0.5 oz.

 Connector 3.5 mm mono jack plug
 Cable length BE9199: 2.5 m, 8.2'
BE9200: 0.75 m, 2.5'
Microphone type Piezoelectric

Colour White

 Environment For indoor use only
External trig cable
Connects an external trigger source to Visit
The external trigger cable is used to connect an external
trigger source to a Visit product. Use it for instance to
connect an existing doorbell to the telephone transmitter
and be alerted when someone rings the doorbell.
Technical specifications
 Weight 25 g, 0.9 oz.
Connector 3.5 mm mono jack plug

Cable length 0.5 m, 1.6'

Colour White

Voltage
2 – 30 VDC
U
3 – 24 VAC
See the relevant Visit product section for detailed
information.
BE9199 | BE9200
BE9253
Tip
Ring
Sleeve
54