Asi Input Settings; Asi Output Settings - DekTec DTM-3200 User Manual

DTM-3200 – OEM Ethernet TSoIP Converter
User Manual

4.4.8 ASI input settings

The ASI input settings are available only if the DTM-3200 is configured as ASI-to-IP converter.
Manageable Items - Category 0x83 – ASI input settings
Nr Variable
0x01 Packet size
0x02 Physical port
0x03 Status
0x04 TS rate
0x05 Valid count
0x06 Violation count
0x07 Input select
This category requires an index to be sent with each command.

4.4.9 ASI output settings

The ASI output settings are available only if the DTM-3200 is configured as IP-to-ASI converter.
Manageable Items - Category 0x84 – ASI output settings
Nr Variable
(hex)
1 ASI packet size
2 Physical port
3 TS rate
This category requires an index to be sent with each command.
Description
0 = Generate IP packets with 188-byte
transport packets
1 = Generate IP packets with 204-byte
transport packets
2 = Use size of incoming packets
Physical port number of ASI input;
always 1 for the DTM-3200
0 = Valid ASI signal is received
1 = No carrier detected
2 = Failed to lock to ASI input
3 = Input rate is below minimum
supported rate
Transport stream rate (in bps@188) of
the received ASI stream
Number of received bytes
Number of ASI code violation detected RO
0 = Autoselect (default)
1 = Select SPI input
2 = Select ASI input
Description
0 = Generate 188-byte packets
1 = Generate 204-byte packets
2 = Use size of received packets
Physical port number of ASI output;
always 1 for the DTM-3200
TS rate (in bps@188) of the generated
ASI stream
29
Access Type
R/W (V) int8
RO int8
RO int8
RO int32
RO int64
int64
R/W int8
Access Type
R/W (V) int8
RO int8
RO int32