Table of Contents
Advertisement
DTM-3200 – OEM Ethernet TSoIP Converter
User Manual
4.4.3 Overall configuration
The configuration settings are used to switch the mode and application of the DTM-3200. When
settings 0x01 'Mode' or 0x02 'Application' are changed the DTM-3200 is rebooted automatically.
Manageable Items - Category 0x02 – Overall configuration
Nr
Variable
0x01 Mode
0x02 Application
0x03 Volatile storage
When the 'Volatile storage' variable is set to 1, any changes made to settings with acces
R/W (V), will be lost after reboot.
4.4.4 Network settings
The network settings are used to configure the IP address, subnet mask and gateway for the netw
connection. The MAC address can be read from a read-only variable.
Manageable Items - Category 0x03 – Network settings
Nr
Variable
0x01 IP address
0x02 Subnet mask
0x03 Gateway
0x04 DHCP enabled
0x05 Reboot
0x06 MAC-address
When the 'DHCP enabled' behavior variable is read, it indicates whether a static IP address or DH
is used.
For DTM-3200 package versions up to v1.3, the following behavior applies:
To switch from a statically assigned IP address to DHCP, write 1 to the 'DHCP enabled
variable. Effectively, this action causes 0.0.0.0 to be written to IP address, Subnet mask and
Gateway. Writing 0.0.0.0 to IP address therefore has the same effect as writing 1 to 'DHCP
enabled': In both cases, the DTM-3200 switches to a dynamically assigned IP address through
DHCP (after a reboot).
To switch from DHCP to a statically assigned IP address, write the new static IP address, subnet
mask and gateway to the corresponding variables. It must be noted that switching to a static IP
address cannot be achieved by writing 0 to the 'DHCP enabled' field.
Starting with DTM-3200 package version v1.4, the 'DHCP enabled' behavior has been altered, to
provide the user with a more convenient way to enable or disable the DHCP client:
Description
0 = ASI to TSoIP
1 = TSoIP to ASI
0 = Failsafe application
1 = Normal operation
See section 4.5.3 for further information
0 = Disabled, settings stored in flash
1 = Enabled, settings stored in ram
Description
IP address of the DTM-3200
Subnet mask
Gateway
0 = Use static IP address
1 = Use DHCP
1 = Reboot
MAC address of the DTM-3200
23
Access
Type
R/W
int8
R/W
int8
R/W
int8
Access
Type
R/W
IP addr
R/W
IP addr
R/W
IP addr
R/W
int8
WO
int8
RO
int48
Advertisement
Table of Contents
