Table of Contents
Advertisement
DTM-3200 – OEM Ethernet TSoIP Converter
User Manual
Nr
Variable
0x16 Rate-estimation
mode
0x17 Jitter error
counter
0x18 Lock error
counter
0x19 Delay factor
This category requires an index to be sent with each command.
4.4.7 IP transmit settings
The IP transmit settings are available only if the DTM-3200 is configured as ASI-to-IP converter.
Nr
Variable
0x01 Enable
0x03 FEC enable
0x04 FEC #columns*
0x05 FEC #rows*
Manageable Items - Category 0x81 – IP receive
0 = Bitrate is estimated using PCRs if
possible, otherwise the bitrate is
estimated without PCRs
1 = Bitrate estimation is disabled;
Packets are buffered, and transmitted
with a fixed delay
2 = Bitrate is estimated without the use
of PCRs
3 = Bitrate estimation is disabled;
Packets are routed to the ASI port
immediately
Counter that keeps the number of IP
jitter errors for this channel. A jitter error
occurs when an incoming IP packet has
a jitter that exceeds the Jitter Tolerance.
During normal operation this counter
should remain constant
Counter that keeps the number of
channel restarts. A channel is restarted
only under adverse circumstances, like
large jitter of IP packets in combination
with packet loss. A channel restart
causes a signal interruption for this
channel of about 1 second. During
normal operation this counter should
remain constant
The channel's delay factor in us. Delay
factor is a measure of the maximum
jitter on the IP packets received for this
channel
Manageable Items - Category 0x82 – IP transmit
0 = Disable
1 = Enable
0 = Disable generation of FEC packets
1 = Enable generation of FEC packets
1..20; #FEC columns generated
4..20; #FEC rows generated
Description
Description
27
Access
Type
R/W (V)
int8
RO
int32
RO
int32
RO
int32
Access
Type
R/W (V)
int8
R/W (V)
int8
R/W (V)
int16
R/W (V)
int16
Advertisement
Table of Contents
