Getting Started; Introduction; Configuration #1: Converting Tsoip To Asi; Test Set-Up - DekTec DTM-3200 User Manual

DTM-3200 – OEM Ethernet TSoIP Converter
User Manual

2. Getting Started

2.1 Introduction

This section provides a walkthrough for getting started with the DTM-3200. Two set-ups a
described: one for receiving a Transport Stream over IP (TSoIP) and converting it to ASI, and one t
other way around, receiving ASI and converting it to TSoIP.
The description below assumes that the DTM-3200 development kit (see Appendix B) is u
control the DTM-3200 over USB from a development PC. The GUI tool Dtm3200Util is used
apply settings and observe status.

2.2 Configuration #1: Converting TSoIP to ASI

This set-up will receive a TSoIP stream and transmit the stream on the ASI interface.

2.2.1 Test set-up

For testing this configuration, a TSoIP transmitter
TSoIP test signal. To observe the output of the DTM-3200, an ASI receiver is helpful.
This tutorial assumes that the network dynamically assigns IP addresses through DHCP, and that
source generates a TSoIP stream with the following parameters:
Protocol
Destination address
UDP Port

2.2.2 Configuring the TSoIP to ASI conversion

Using Dtm3200Util, configure the DTM-3200 as shown in the table below. The receive process is
first disabled before changing configuration parameters. When all parameters have been set, the
DTM-3200 is enabled again.
Category
1 0x81: IP receive
2 0x81: IP receive
3 0x81: IP receive
4 0x81: IP receive
5 0x81: IP receive
6 0x81: IP receive
7 0x84: ASI/par. output 1: Packet size
8 0x81: IP receive
1 If you do not have a suitable TSoIP transmitter and/or ASI receiver, this functionality can for example be realized with
PC and a DekTec DTA-2160 I/O card in it. Please consult your local DekTec representative for more information.
1 should be present on the network to generate a
UDP
224.1.1.1
5678
Setting
2: Enable
1: Addressing method 1 = Multicast
4: FEC enable
10: UDP port
11: IP-to-Output delay 100 = 100ms
12: Multicast address 224.1.1.1
2: Enable
11
Value
0 = Off
0 = Off
5678
0 = 188-byte MPEG-2 packets
1 = On