Table of Contents
Advertisement
DTM-3200 – OEM Ethernet TSoIP Converter
User Manual
The DTM-3200 will now receive a TSoIP stream and transmit this stream on the ASI port. The statu
LED will be green to indicate successful transmission of the TS on the ASI output. If no TSoIP strea
is received, the status LED will be red.
2.3 Configuration #2: Converting ASI to TSoIP
This set-up will receive a stream on the ASI interface and transmit the stream over IP.
2.3.1 Test set-up
The equipment and tools are similar to the ones listed in §2.2.1 In this case we need an external A
source and a TSoIP receiver on the network.
2.3.2 Configuring the ASI to TSoIP conversion
The settings below (sequential order) set up the DTM-3200 for ASI to IP conversion. No FEC will be
generated in this example.
Category
1
0x82: IP transmit
2
0x82: IP transmit
3
0x82: IP transmit
4
0x82: IP transmit
5
0x82: IP transmit
6
0x82: IP transmit
7
0x82: IP transmit
8
0x83: ASI/par. input 1: Packet Size
9
0x82: IP transmit
Setting
1: Enable
3: FEC Enable
6: IP Address
8: UDP Port
9: #TP per IP
10: Protocol
13: Time to Live
1: Enable
12
Value
0 = Off
0 = Off
224.1.1.1
5678
3 = 3 Transport Packets per IP pckt
0 = UDP
100
0 = 188-byte MPEG-2 packets
1 = On
Advertisement
Table of Contents
