Advertisement
2 SETUP
4
Condition
Packaging V12
–
Remove the box and the plastic packaging.
Info
An assistant prevents the motorcycle from falling
over.
To avoid damaging the motorcycle during the setup,
leave the protective film on the vehicle until you
E00850-10
have finished.
–
Remove and unpack the separate enclosure and compo-
nents. Check that the scope of supply is complete using
the enclosed packing list.
–
Remove the two cable ties on the triple clamp.
–
Have a lift stand available.
Lift stand (78129955100)
–
Together with an assistant, take the vehicle off the pallet.
–
Position the vehicle on a lift stand.
–
Check the vehicle and components for transport damage.
–
Install the shock absorber. (
402051-01
–
Position the turn signal indicator lamp
tion instrument bracket.
H01768-10
–
Position the connector board and combination instrument
on the upper triple clamp.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
–
Route the clutch line with the clutch master cylinder
toward the front between the upper and lower triple
402736-10
clamps.
–
Install the fork legs. (
p. 22)
1
in the combina-
2
.
M6
10 Nm (7.4 lbf ft)
p. 22)
Advertisement
