Info
Read the notes in the 12 V battery accessory pack.
–
Charge the 12 V battery. (
(250 EXC‑F US)
–
Install the headlight mask with the headlight. (
–
Install the 12 V battery. (
(EXC‑F EU/AU/AR/BR, EXC‑F Six Days)
–
Remove the fuel tank. (
–
Position the turn signal cable harness.
–
Insert the indicator lamp with the black and violet cable
colors into socket
S01393-10
–
Position the turn signal on the headlight mask on both
sides, mount nuts with washers and tighten.
–
Connect the plug-in connector of the right turn signal using
the black and brown cables of the turn signal cable har-
ness.
–
Connect the plug-in connector of the left turn signal using
the violet and brown cable colors of the turn signal cable
harness.
E00484-10
Info
Pay attention to where the brake line is routed when
doing so.
–
Connect plug-in connector of the headlight.
–
Connect plug-in connector of the turn signal switch.
–
Secure turn signal relay
the connector.
–
Install the headlight mask with the headlight. (
–
Route the turn signal cable harness from the front to the
rear as far as the battery compartment.
–
Position and secure the turn signal cable harness using
cable ties on the main wiring harness under the rubber
straps of fuel tank support.
S01394-10
p. 30)
p. 28)
p. 32)
4
.
5
with a cable tie and plug in
SETUP 2
p. 20)
p. 20)
11