KTM 250 EXC-F Six Days 2019 Setup Instructions page 16

2 SETUP
14
–
Carefully pass the tail light cable through the frame, pay-
ing attention to the plug as you do so.
–
Position the license plate holder on the rear.
–
Mount and tighten screws
E00495-10
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
–
Mount and tighten screw
tact disk.
Guideline
Remaining screws,
chassis
E00489-10
–
Connect the tail light plug-in connector to the main wiring
harness plug-in connector.
–
Mount the engine control unit on the holder.
Info
The wiring harness runs under the engine control
unit.
E00498-10
bo
.
bl
with the collar bushing.
M6 10 Nm (7.4 lbf ft)
bm
.
M6 10 Nm (7.4 lbf ft)
bn
with negative cable and con-
M6 10 Nm (7.4 lbf ft)