KTM 250 EXC-F Six Days 2019 Setup Instructions page 28

3 WORK
3.12
3.13
26
Mounting the seat
V00343-10
V00342-10
Removing the 12 V battery
Note
Environmental hazard 12 V batteries contain environmentally hazardous materials.
–
Do not dispose of 12 V batteries as household waste.
–
Dispose of 12 V batteries at a collection point for used batteries.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
–
Mount the front of the seat on the collar bushing of the fuel
tank, lower the seat at the rear, and push the seat forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
Preparatory work
(EXC‑F EU/AU/AR/BR, EXC‑F Six Days)
–
Press and hold the kill switch
until the engine stops.
(250 EXC‑F US)
–
Turn the ignition key in the ignition lock to the position
while the engine is idling.
–
Remove the seat. ( p. 25)
1
.
M6 10 Nm (7.4 lbf ft)
while the engine is idling