Electronics Line Prime Quick Start Installation Manual page 8

Step 3: Test the detectors
1. Go to the main display press '√ʹ.
2. Enter your installer code (default code '1111').
3. Enter [7]>[07]>[2] (Service > Transmitters > TX Test) to initiate the TX communication
test. This test enables you to identify transmitters and test their signal strength.
4. Activate the transmitter you wish to test; the transmitter's details appear on the
Prime LCD and a sequence of tones is heard indicating the transmitter's signal
strength (Table 4).
Signal Strength
0-2
3-5
6-8
8-9
Table 4: Signal strength
In addition the display shows the detectors status using the abbreviations (as seen in
Table 5).
Item Description...
OK The transmitter is
functioning correctly
TA Tamper condition
BT Battery low
Table 5: Abbreviations
Tones
1 Tone
2 Tones
3 Tones
4 Tones
Item Description...
OS The transmitter is not
synchronized
NA The transmitter is inactive
8
Note:
If the signal strength is less than
6, move the transmitter to a
better location.