Table of Contents
Advertisement
1. Introduction
Thank you for choosing Prime wireless intruder control panel. This quick start guide manual
describes the main steps for installing and programming the Prime Control System using the
keypad on the main unit. To view the full version of the Installer manual, please refer our website
www.electronics-line.com
2. System Installation
1.
Open the main unit housing.
2.
Place the rear main unit in position against the wall and mark the upper and lower
mounting holes.
Note: If required, mark the hole for the rear tamper. The hole is located behind the main
board.
3.
Install wall anchors in the appropriate positions
4.
Thread the power cable through the wiring hole on the back cover and connect the cable
to the AC power input on the main board (10).
Caution: Do not apply AC power at this stage.
5.
Connect the telephone and telephone line (2) to their connectors on the Communication
module.
6.
Optional: If required connect external modules to the main unit such as: home
automation module (15) , GSM communication module (14). If GSM module is required
connect insert a SIM card as required.
7.
Optional: Some devices, such as wireless siren, WSM, and wireless terminal require the
plug-in transmitter (4). Mount the transmitter on the Control System's main board. For
more details refer to the full installer manual.
8.
Connect the battery pack (13) to the connector (12) on the main board.
9.
Enter the master user code number (default 1234) to silence the alarm.
10. Mount the control system to a wall
11.
Close the front cover and apply AC power
Note:
To recognize the external modules you should perform a system scan to program the
modules that are connected to the system. A system scan is performed from the main
menu: [9] Programming > [7] Initialize > [5] Find Modules > √. The generated list displays
the modules recognized by the system then save. If a connected module is not included in
the list, check the wiring connections and run this scan again.
.
3
Advertisement
Table of Contents
Need help?
Do you have a question about the Prime and is the answer not in the manual?
Questions and answers