System Programming; Keys Menu Navigation; Enter Installer Programming Mode; Registering Wireless Devices - Electronics Line Prime Quick Start Installation Manual

3. System Programming

3.1. Keys Menu Navigation

This manual explains how to program the Prime from the keypad located on the main unit. Table
1 describes the uses of the keypad keys during programming.
Enter / Save (to move to the displayed menu or to save the updated data).
Used to cancel the current selection or to return to the previous menu level.
To scroll up or down through the menu options
/
[1]-[0]
Table 1: Keypad usage

3.2. Enter Installer Programming mode

1. Go to the default display press √.
2. Enter your installer code (the default installer code is '1111').
3.
Using the arrow keys, select [9] Programming.

3.3. Registering Wireless Devices

In order to enable the Prime to recognize a device, its transmitter must be registered.
It is recommended to register all devices to the control panel before installing. To install the
wireless devices/accessories temporarily fit them to the desired locations, and then perform a range
test. Testing may show that you should relocate the panel or some of its devices/accessories.
Note:
For wireless siren registration refer to the full installer manual.
1. To enter numeric values when required.
2. For quick key programming. Press the key number to access a programming
option.
3. To edit descriptors.
5