Elecro Engineering Titan Optima Series Installation & Operating Manual page 9

The digital display
'NORMAL' and the graphical red
coloured thermometer
'Animated' whenever the heating
device is switched 'ON'.
The actual pool water temperature is shown in the upper area of the display. The required temperature is
shown in the lower area of the display. The required water temperature can be adjusted by touching the
'UP / DOWN' touch button keys until the required temperature is displayed, adjustments are in 0.1°C
increments.
Priority of Heating is a function that ensures your pool water is constantly maintained at your required
temperature. When Priority of Heating is activated the Symbol
The heater will then monitor the pool water temperature and start both the pool circulation pump and
heating process when necessary.
Time Switching Delay
To prevent overheating of the switch components within the heater caused by frequent on/ off switching
(cycling) the heater has been pre-programmed with a time delay function.
When time switching delay is activated the message display will show 'HEATER DELAY' for 2 minutes.
Differential
When the pool water has reached the required temperature the heating device will switch off and will not
switch back on until the water temperature has fallen 0.6°C below the required temperature.
Operating Modes
There are five operating modes:
Normal
will show
will be
Timer
will be displayed on the screen.
Priority Installation Standby
9