Elecro Engineering Titan Optima Series Installation & Operating Manual page 12

CLOCK Setup
Touch the 'UP' / 'DOWN' button keys to display the next option which is 'CLOCK' touch the 'O.K' button
key to select, the display will show 'SET TIME' and the current clock time, touch the 'UP' / 'DOWN' button
keys to change the clock time, touch the 'O.K' button key when the time is correct to save.
NOTE: The time can only be set in the 24-hour format.
TIMER Setup
After selecting 'O.K' for the 'CLOCK' setup the display will then revert back to show 'CLOCK', touch the
'UP' / 'DOWN' button keys until 'TIMER' is displayed, touch the 'O.K' button key to select, 'TIMER 1' will
be displayed, touch the 'O.K' button key to select and 'SET TIMER 1 ON' will be displayed, touch the 'UP'
/ 'DOWN' button keys to set the required time, touch the 'O.K' button key to save the setting, 'SET TIMER
1 OFF' will be displayed, touch the 'UP' / 'DOWN' button keys to set the required time, touch the 'O.K'
button key to save the required time, the display will then show
'TIMER 2' repeat the same procedure for all four 'ON' / 'OFF' timer settings, select 'EXIT'. If any Timers
are not required set the 'ON / OFF' times the same.
The timer mode allows you to set up 4 on and off time periods when you would like heating to take place.
These can be set to take advantage of off-peak energy tariffs, or to ensure your pool is at the required
temperature during specific time periods.
The heater allows you to override the time clock at any point by activating the Priority of Heating Mode
explained on page 15.
NOTE: The time clock will only control the heating time periods and not the filtration pump
cycles.
12