Elecro Engineering Titan Optima Series Installation & Operating Manual page 10

The required Modes are selected by touching the
'M' button key, each touch causes the mode to
change to the next mode. The display will indicate
which mode is currently selected together with the
clock time.
(Example illustrated 'INSTALLATION' mode)
Installation Mode
When entering Installation mode, the heater and pump will immediately be turned off (if they are
on) and will not be permitted to be turned on while the heater remains in any of the setup menus.
On exiting the 'Installation' mode the heater will revert to the 'Normal' mode and follow the same
procedure as if first entering that mode, the display will reflect this.
•
LANGUAGE (English, French, German, Spanish and Russian)
•
UNITS (temperature units; Centigrade or Fahrenheit)
•
CLOCK (set current time)
•
TIMER (four-time settings for switching the heating device 'On' and 'Off')
•
PROBE CAL (Temperature calibration adjustment)
•
MODBUS (Set Baud rate, address and parity for BMS connection)
•
FACTORY (Access restricted)
•
EXIT
Language Setup
Enter the 'INSTALLATION' mode by touching the 'M' button key repeatedly until 'INSTALLATION'
appears at the top of the display then touch the 'O.K' button key.
10