Advertisement
Quick Links
GUARANTEE
Your Elecro heater is guaranteed for one year from the date of purchase against faulty
workmanship and materials.
ELECRO ENGINEERING LTD will replace or repair, at it's discretion, any faulty units or
components returned to the company for inspection. Proof of purchase may be required.
ELECRO ENGINEERING LTD will not be liable in cases of incorrect installation of the
heater, or inappropriate use, or neglect of the heater.
CE Declaration Of Conformity
Elecro declares that the herewith products or ranges
ELECTRIC SWIMMING POOL HEATER RANGE
Are in conformity with the provisions:
of the ELECTROMAGNETIC COMPATIBILITY directive 89/336/EEC, as amended
93/068/EEC. Controlled by AEMC Measures laboratory—technical report no P96045T
The harmonised standards have been applied: EN 55014—EN 55104
of the LOW VOLTAGE directive 73/23/EEC.
The harmonised standards have been applied
EN 60335-2-35
ELECRO ENGINEERING LTD
Tel: +44 (0)1438 749 474
Fax: +44 (0)1438 361 329
Website: www.elecro.co.uk
E-mail: info@elecro.co.uk
© Copyright 2004 Elecro Engineering Limited
EN 55011
EN 55022
CEI 801-4
CEI 801-2
CEI 801-3
Unit 14
Leyden Road
Stevenage
Hertfordshire
SG1 2BW
UK
TiTANIUM
Swimming Pool Heater
Installation Instructions
& Operating Manual
P
R
C
LEASE
EAD
AREFULLY
Incorrect Installation Will Effect Your Warranty
Do Not Discard, Keep For Future Reference
B
I
EFORE
NSTALLING
Advertisement
Related Manuals for Elecro Engineering TiTANIUM
Summary of Contents for Elecro Engineering TiTANIUM
-
Page 1: Ce Declaration Of Conformity
Your Elecro heater is guaranteed for one year from the date of purchase against faulty workmanship and materials. ELECRO ENGINEERING LTD will replace or repair, at it’s discretion, any faulty units or components returned to the company for inspection. Proof of purchase may be required. - Page 2 Your Elecro heater must be screw fixed to a firm base or wall. The heater MUST be [Blank Page For Your Notes] horizontal and upright i.e. with the control enclosure located above the Titanium flow tube (see diagram below). Under no circumstances should the heater be oper- ated in any other orientation.
- Page 3 The water entering my pool doesn’t feel much warmer It is essential that the pipe work connecting to and from the heater has a minimum The temperature gain of the water after it has passed through the heater will be di- bore (internal diameter) of 1¼’’...
-
Page 4: Troubleshooting
LECTRICAL ONNECTION ROUBLE HOOTING ONTINUED The heater must be installed in accordance with the country / regional requirements Possible Cause 2.) The high limiting thermostat has tripped. & regulations. In any event the work must be carried out by a qualified electrician, Remedy;... -
Page 5: Water Quality
Total Bromine MAX: 4.5-mg/litre To confirm - increase the set point value by turning the temperature set point dial to Elecro Titanium heaters are suitable for use on saline (salt) water pools. a value greater than the current water temperature. -
Page 6: Hour Timer
Switch Position Function 24 H (If Fitted) IMER In this position the time clock is I = Top Position Manual Override = ON: Programming Guide by-passed, and will not affect the operation of the heater. Setting Up - The Outer dial will need to be set to the current time (when the heater = Middle Position 24 Hour Timer = ON: Timed Operation Only.