Mmc 738 : Clear Registration - Samsung Office DECT 8000 Installation And Programming Manual

Hide thumbs

Table Of Contents

Table of Contents

MMC 737 : : DECT System

MMC 737

D D e s

e s c r i p t i o n

c r i p t i o n

Used to identify your DECT system and the handsets you register with your system.

The DECT System Code for your system is made up of two fields: the System ID which is three hexadecimal

digits in the range 011 to 999; and the Auth Code (short for Authentication Code) which is four hexadecimal

digits in the range 0000 to 9999. The default values are 000 and FFFF respectively.

You must use this MMC to change the default values for the values you have been provided with by your

supplier. If you do not change the defaults you will not be able to register handsets.

Once you have entered your new System ID and Auth Code using this MMC you can then begin registering

your handsets with the Auth Code. The system checks the Auth Code entered for each handset against the

DECT Auth Code. If it is the same, the registration procedure continues; otherwise, the DCS rejects the registra-

tion procedure.

Caution: Only the system administrator and/or installer should be allowed access to change the DECT System

Code and register handsets.

P P r o g r a m K e y s

r o g r a m K e y s

Volume Up/Down

Keypad

Soft keys

SPEAKER

HOLD

A A c t i o n / D i s p l a y

c t i o n / D i s p l a y

Press TRSF 737

Display shows

Press RIGHT soft key to move cursor and enter AUTH

CODE via keypad (e.g. 1234)

Press RIGHT soft key and press Up or Down key to select

SYSTEM ID

Press RIGHT soft key to move cursor and enter SYSTEM ID

via keypad (e.g. 567)

Press TRSF to store and exit

Press SPEAKER to store and advance to next MMC

D D efault Data

efault Data

SYSTEM ID: 000

AUTH CODE: FFFF

R R e l a t e d M M C

e l a t e d M M C