To Remove/Replace Holder - Arai RX-7GP Manual

r
(4)
(5)
12
q
w
!
(1)
(2)
(3)
English
To replace the shield, holding the shield in approximately its fully open
position, slip the shield into the front opening of the holder. Push the shield
further into the holder until it falls in place and is fully locked.
Repeat for the other side.
NOTE:
If the approach angle of the shield is incorrect, the shield cannot enter
fully into the holder and thus cannot be installed.
Work the shield up and down to check the operation.

TO REMOVE/REPLACE HOLDER

To remove the holder, first remove the shield. Next, push up the release
lever (1), and, with a flat rod like a house key or a flat bladed screwdriver,
push the red clip under the holder backwards (2) until the holder pops up.
Then, lift the holder up toward the top of the helmet to remove completely.
To replace the holder, position top tab on the backside of the holder on
the base plate (3), align the holder with the recess of the helmet shell (4)
and push in around the lower part of the holder (5) firmly toward the shell
until it clicks in to place and is fully secured to its base plate. Reinstall the
shield as per previous instructions.
WARNING:
If the holders are not correctly reinstalled, these may come off when
you try to replace the shield. Be sure the holders are fully secured to
their bace plates before you replace the shield.