To Operate Airflow Spoiler; Rx-7Gp / Corsair-V / Quantum-St / Rx-Q / Signet-Q / Rebel; To Remove/Replace Shield - Arai RX-7GP Manual

q
10
w e
English
To install the breath deflector, first insert the center of the deflector in
the receiving slot and then push in the sides working from the center
outwards.
NOTE:
If you do not use the deflector we recommend you to install Anti-mist spacer
(optional) in this place as it actually acts as an anti mist ducting device.

TO OPERATE AIRFLOW SPOILER

RX-7GP / CORSAIR-V / QUANTUM-ST / RX-Q / SIGNET-Q / REBEL

To deploy the spoiler in the down position, simply pull it down by grasping
the center of its chin curtain.
To retract the spoiler, simply push it up with the heel of your hand.

TO REMOVE/REPLACE SHIELD

To remove the shield, first place it in the fully open position.
NOTE:
The shield cannot be removed from any other position, as the lock
system will be engaged.
When the shield is in its fully open position, a release lever deploys from
the front edge of the shield holder. Push up the lever until a click is heard
to release the shield from the mechanism (do not continue to push on
levers), and pull out the shield from the holder.
Repeat for the other side.