IFM Efector600 TN2531 Operating Instructions Manual page 12

9 Parameter setting
During parameter setting the unit remains in the operating mode It continues its
monitoring function with the existing parameters until the parameter setting has
been completed
9.1 General parameter setting
3 steps must be taken for each parameter setting:
1
Selection of the parameter
► Press [Mode/Enter] until the re-
quested parameter is displayed.
2
Setting of the parameter value
► Press [Set] and keep it pressed
> Current setting value of the param-
eter flashes for 5 s
> After 5 s: Setting value is changed:
incrementally by pressing the button
once or continuously by keeping the
button pressed
Numerical values are incremented continuously For reducing the value: Let the dis-
play move to the maximum setting value Then the cycle starts again at the minimum
setting value
3
Acknowledgement of the parameter
value
► Press [Mode/Enter] briefly
> The parameter is displayed again
The new setting value is stored
Setting of other parameters
► Start again with step 1
Finishing the parameter setting
► Press [Mode/Enter] several times until the current measured value is displayed or wait
for 15 s
> The unit returns to the operating mode
• If [SLoc] is displayed when attempting a modification of a parameter value, the sensor is
locked via software This locking can only be removed via a parameter setting software
• In case of parameter setting with the user interface of the ifm Container program, the
values can be directly entered in the specified fields
• For IO-Link parameter setting → device-specific parameter lists at: www.ifm.com → Select
your country → Data sheet direct:
12
���������� ���
���������� ���
���������� ���