Sun Microsystems Fire 280R Setup And Rackmounting Manual page 12

Hide thumbs Also See for Fire 280R:

Table of Contents

Use the key for controlling the system in "Setting Up the System" on page 19. The

wrist strap is not needed for the rackmounting procedures. Both the key and the

wrist strap are needed for procedures described in the Sun Fire 280R Server Service

Manual and the Sun Fire 280R Server Owner's Guide.

The accessory box includes a plastic bag of hardware containing screws, nuts, and

washers that are shown below in actual size.

You need 8 of the 10-32 x 3/4 screws to attach the slide assemblies to the rack. After

installing the slide assemblies, any unused hardware is a spare piece.

Note – Bar nuts are not used in Sun rack enclosures. Bar nuts are required (but not

included) for non-threaded rack enclosures. See your rack enclosure instructions for

more information.

Sun Fire 280R Server Setup and Rackmounting Guide • January 2001

Screws

Flat

washer (8-32)

(10-32 x 3/4)

(spare)

Locking

nut (8-32)

(spare)

Table of Contents

Need help?

Do you have a question about the Fire 280R and is the answer not in the manual?