Table of Contents
Advertisement
5.7 Engine oil
5.7.1 To change the oil
Drain the used oil while the engine is warm. Warm oil
drains quickly and completely.
1. Place n approved container (A) below the engine to
collect the used oil.
2. Remove the oil filler cap dipstick (B), the drain plug
(C) and sealing washer (D).
B
A
Figure 1
3. Tilt the product to make sure the oil comes out of
the drain plug hole.
4. Let the used oil drain completely into an approved
container.
5. Install the drain plug with a new sealing washer,
and tighten it securely.
Note: Improper disposal of engine oil can be harmful
to the environment. Dispose of used motor oil prop-
erly. Put it in a sealed container, and take it a recy-
cling center Do not throw it in the trash, pour it on the
ground, or pour it down a drain.
D
C
5.7.2 Engine oil recommendation
Select the appropriate engine oil viscosity based on the
ambient temperature and use the SAE, Service Grade
Viscosity.
F
-20
0
20
C
-30
-20
-10
Figure 2
SAE 10W-30 is recommended for general use. Other
viscosities shown in the chart may be used when the
average temperature in your area is within the recom-
mended range.
5.7.3 To fill the product with engine oil
1. Put the engine in a level position.
2. Fill with recommended oil to the edge of the oil filler
hole.
Engine oil capacities:
W100D:
1.65
L
3. Install the oil filler cap and dipstick and tighten
securely.
Repair instructions
10W-30
SAE 30
32
40
50
60
80
0
10
20
30
English - 17
100
40
Advertisement
Table of Contents
