Closing The Door; Replacing The Lamp - Electrolux IG2085SN User Manual

Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the ActionFreeze,
or after changing the tem-
perature.
Water flows on the floor.
Temperature cannot be set. The ActionFreeze or
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.

7.2 Closing the door

1. Clean the door gaskets.
Possible cause
The door is not closed
correctly or the gasket is
deformed/dirty.
This is normal, no error
has occurred.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
Shopping Function func-
tion is switched on.
The appliance is in dem-
onstration mode.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
The door has been
opened often.
The ActionFreeze function
is switched on.
There is no cold air circu-
lation in the appliance.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective

7.3 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Solution
Refer to "Closing the door".
The compressor starts after a
period of time.
Attach the melting water out-
let to the evaporative tray.
Switch off ActionFreeze or
Shopping Function manually,
or wait until the function re-
sets automatically to set the
temperature. Refer to "Ac-
tionFreeze or Shopping Func-
tion function".
Keep the OK pressed for ap-
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.
Let the food products tem-
perature decrease to room
temperature before storage.
Open the door only if neces-
sary.
Refer to "ActionFreeze func-
tion".
Make sure that there is cold
air circulation in the appli-
ance.
"Installation".
door gaskets. Contact the Authorised
Service Centre.
ENGLISH 11