Table of Contents
Advertisement
12
www.electrolux.com
Problem
The compressor does not
start immediately after
pressing the FastFreeze,
or after changing the tem‐
perature.
Temperature cannot be
set.
Door is misaligned or inter‐
feres with ventilation grill.
The temperature in the ap‐
pliance is too low/too high.
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
Possible cause
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
The FastFreeze or Shop‐
pingMode function is
switched on.
The appliance is not level‐
led.
The temperature regulator
is not set correctly.
The food products' temper‐
ature is too high.
The thickness of the frost
is greater than 4-5 mm.
The door has been opened
often.
The FastFreeze function is
switched on.
There is no cold air circula‐
tion in the appliance.
3. If necessary, replace the defective
Solution
Position the water drain‐
age plug in the correct
way.
Wrap the food products
better.
Refer to "Operation" chap‐
ter.
The compressor starts af‐
ter a period of time.
Switch off FastFreeze or
ShoppingMode manually,
or wait until the function re‐
sets automatically to set
the temperature. Refer to
"FastFreeze or Shopping‐
Mode function".
Refer to "Levelling".
Set a higher/lower temper‐
ature.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Defrost the appliance.
Open the door only if nec‐
essary.
Refer to "FastFreeze func‐
tion".
Make sure that there is
cold air circulation in the
appliance.
door gaskets. Contact the Service
Center.
Advertisement
Table of Contents
