M 7200 Sw - Operating Controls - Teufel LT 7 Series Technical Specifications And Operating Manual

8. M 7200 SW – Operating controls
The M 7200 SW THX subwoofer features a user display
on the front side of the cabinet. This display shows
the user menu for setting up and operating the sub-
woofer. There are five buttons below the display for
navigating through the individual menu options. The
same buttons are provided on the remote control.
Figure: M 7200 SW – Display and controls
How to use the display and controls
4
4
4
4
18 Teufel · LT 7
Display
The display consists of two lines, each of which
can show up to 24 characters. The top line indi-
cates the currently selected menu; the bottom
line indicates the current setting for the menu
item.
Up/Down
Use these two buttons to select menu items
and change settings. Press "Up" to increase the
value of a parameter (e.g., level or frequency);
press "Down" to decrease the value. When you
are navigating through the menu, press "Up" to
skip to the previous menu item, or "Down" to
skip to the next menu item.
Return
The menu structure of the M 7200 SW THX
Select is subdivided into several layers. Press
the "Return" button to navigate to the next
higher menu level. If the current menu level is
the first/highest level, pressing the "Return"
button will exit the menu.
Enter
The "Enter" button has two different functions:
Press "Enter" to open the first menu, and to se-
lect individual submenus(i.e., to change to low-
er menu levels). When you are editing the menu
parameters with "Up"/"Down" , press "Enter" to
confirm and save the current value. The saved
value is indicated by the symbol.
Mode Surround/Stereo
4
Use this button to switch the subwoofer be-
tween 2.1 (stereo) and 5.1 (surround) mode. The
selected mode is indicated at the top right
of the display. Please note that the "Cinch Pre
Out" menu item is only used in 2.1 operation
and is therefore not available in 5.1 mode. At-
tention: You can only switch between the op-
erating modes when you are on the top-most
menu level.
Standby/On
4
Press the "Standby/On" button to either acti-
vate the subwoofer or put it in standby mode.
Note: This button is only provided on the re-
mote control. When the subwoofer is in standby
mode, you can also press any button on the
front panel to activate it.
Figure: Subwoofer remote control
The buttons on the remote control have the same
functions as the buttons below the display on the
subwoofer's front panel. In addition, the remote
control provides a "Standby/On" button.