Fm Radio Operation; Bluetooth Operation - Victrola Jackson Instruction Manual

NOTE: Insert the FM ANTENNA into the FM ANTENNA SOCKET (on the back of the unit) and fully
extend for best reception.
Press the POWER/MODE button to select "FM" mode.
TUNING
• Use the TUNER/PRESET KNOB (on the unit) OR the
remote) to manually adjust the Radio to the desired station.
• Press the PLAY/PAUSE button
buttons (on the unit or remote)
complete, "Stereo" will show on the LCD DISPLAY.
PRESET STATIONS
1. Select the desired station then press and hold the PRESET button (on the remote).
2. "MEMORY P01" will show on the LCD DISPLAY, then press the TUNER/PRESET KNOB to store
the station.
3. Repeat steps 1 and 2 above until the preset stations are full (total of 10 stations).
4. To play the preset stations, press the
PRESET button (on the remote).
1. Press the POWER/MODE button to select "CD" mode.
2. Open the CD DOOR by pressing the OPEN/CLOSE button (on the unit or remote).
3. Place a CD with the printed side facing up. Then close the CD DOOR by pressing the
OPEN/CLOSE button (on the unit or remote) again.
4. After a few seconds, playback will begin automatically.
CONTROLS
• During playback, use the PLAY/PAUSE button
• Press the UP/F-F button (on the unit or remote) once to skip a track.
• Press the DN/F-R button (on the unit or remote) once to restart a track from the beginning.
• Double press the DN/F-R (on the unit or remote).
• Press and hold the
• Press the -10 or 10+ buttons (on the remote) to go back 10 tracks or skip 10 tracks.
PROGRAMMED PLAYBACK
NOTE: Up to 20 tracks on a CD and 99 tracks on an MP3 can be programmed.
Make sure the CD is stopped before setting the programming.
1. While in CD Mode, make sure to stop playback.
2. Press the TUNER/PRESET KNOB (on the unit) or press PROGRAM (on the remote). "MEMORY
P01" will show on the LCD DISPLAY.
3. Select the desired track by using the
press the TUNER/PRESET KNOB (on the unit) or PROGRAM (on the remote) to store the selected
track. Repeat this step until the memory is full (20 total tracks on a CD and 99 total tracks on an MP3).
4. After all desired track have been programmed, press the PLAY/PAUSE button
remote) to play the CD in the programmed order.
5. To cancel programmed playback press the STOP button.
1. Press the POWER/MODE button to switch to "BLUE" (Bluetooth) mode.
2. The LCD DISPLAY will flash "BLUE" indicating the unit is in pairing mode.
3. Make sure your external device has the Bluetooth turned on. Then open the Bluetooth settings
menu on your device and select "VTA-80".
4. The "BLUE" on the LCD DISPLAY will stop flashing and an audible tone will sound indicating the
connection was successful.
5. Use playback buttons on the unit/remote as usual or control playback directly from your external
device.
6. To disconnect the external device, press and hold the STOP button.

FM RADIO OPERATION

(on the unit or remote)
to automatically scan the FM stations in reception. When
UP/F-F or DN/F-R buttons (on the unit or remote) or the
CD OPERATION
UP/F-F or DN/F-R buttons (on the unit or remote) to fast forward or rewind.
UP/F-F and DN/F-R buttons (on the unit or

BLUETOOTH OPERATION

UP/F-F or DN/F-R buttons (on the unit or
OR press and hold the
(on the unit or remote) to play or pause playback.
7
UP/F-F or DN/F-R
remote). Then
(on the unit or