Analyzer - Pc Connection; Reviewing Instrument Configuration; Configuring The Instrument; Gas Measurement Phase - Hach ORBISPHERE 3654 User Manual

5.2 Analyzer - PC connection

For the hardware connection of the analyzer to a PC. Refer to
page
The Configuration, Serial port menu lets you choose one of four serial communication ports,
as follows:

5.3 Reviewing instrument configuration

To review if the analyzer is set up as expected, choose the Configuration, Configuration view
command. You will see a window similar to the following:

5.4 Configuring the instrument

The ORBISPHERE 3654 analyzer can be readily configured for your application using the
following commands in the Configuration menu. The instrument must be connected to your PC
and powered on, in order to change any configuration parameters.

5.4.1 Gas measurement phase

11.
Usually, COM1 is used to connect to a mouse, so try
COM2 first. You may find that a separate program
supplied with your PC may be necessary to activate
this port.
Click on OK to activate the selected port. If the port you
have selected here is available, the WIN3654 program
will return to the main menu. Otherwise, you will see an
RS232 ERRORS message advising you to select
another port.
The instrument can measure N
gaseous sample, but you must select which gas phase to use.
Choosing the WIN3654 program's Configuration, Gas Phase
menu lets you select the gas measurement phase.
Options Setup
Instrument - PC connection on
Some of the parameters
listed, can be changed by
using the WIN3654 program.
However, should you see any
unexpected items listed on
your screen that you cannot
correct, contact your Hach
Lange representative.
or H in either a liquid or a
2 2
27