Wgen:modulation:type - Keysight Technologies InfiniiVision DSOX1204A Programmer's Manual

:WGEN:MODulation:TYPE

Command Syntax
:WGEN:MODulation:TYPE <type>
<type> ::= {AM | FM | FSK}
The :WGEN:MODulation:TYPE command selects the modulation type:
• AM (amplitude modulation) — the amplitude of the original carrier signal is
• FM (frequency modulation) — the frequency of the original carrier signal is
• FSK (frequency-shift keying modulation) — the output frequency "shifts"
Query Syntax
:WGEN:MODulation:TYPE?
The :WGEN:MODulation:TYPE? query returns the selected modulation type.
Return Format
<type><NL>
<type> ::= {AM | FM | FSK}
See Also •
•
•
•
•
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
(see page 798)
modified according to the amplitude of the modulating signal.
Use the :WGEN:MODulation:AM:FREQuency command to set the modulating
signal frequency.
Use the :WGEN:MODulation:AM:DEPTh command to specify the amount of
amplitude modulation.
modified according to the amplitude of the modulating signal.
Use the :WGEN:MODulation:FM:FREQuency command to set the modulating
signal frequency.
Use the :WGEN:MODulation:FM:DEViation command to specify the frequency
deviation from the original carrier signal frequency.
between the original carrier frequency and a "hop frequency" at the specified
FSK rate.
The FSK rate specifies a digital square wave modulating signal.
Use the :WGEN:MODulation:FSKey:FREQuency command to specify the "hop
frequency".
Use the :WGEN:MODulation:FSKey:RATE command to specify the rate at which
the output frequency "shifts".
":WGEN:MODulation:AM:DEPTh"
":WGEN:MODulation:AM:FREQuency"
":WGEN:MODulation:FM:DEViation"
":WGEN:MODulation:FM:FREQuency"
":WGEN:MODulation:FSKey:FREQuency"
on page 679
on page 680
on page 681
on page 682
on page 683
29
:WGEN Commands
689